BASF Global   I   
  

          BASF Home
 
    
 

Q. What radius do you recommend on sharp corners?
A. Molds should be designed with generous radii and fillets wherever possible. A minimum radius of .020" (0.5mm) is recommended at all sharp corners and larger radii are generally beneficial when possible. However, making the radius too large will cause a sink mark on the opposite surface due to the greater mass of material.
Q. How much more draft is needed when molds are textured?
A. 1 draft plus 1.5 draft for each 0.001" (0.025mm) grain depth
Q. Do vents close up?
A. Yes, and vent depth should be checked at each mold cleaning or PM.
Other FAQ categories: Materials | Processing | Machine | Auxiliary Equipment | Back to Technical Services

Can't find the information or answer to your question and want to contact someone for assistance? You can send an e-mail to our expert listed below, who will assist you.

Contact: Derek Luellen
Office: (734) 324-6694
derek.luellen@basf.com

   
Additional Technical Information

UltramidA3X processing handling tips
Cycle Time Calculator

Derek Luellen
(734) 324-6694