| |
| Product Description |
|
Ultrason E 2010 G6 is a 30% glass reinforced, medium viscosity injection molding
PES grade with high rigidity and strength.
|
| Applications |
|
Typical applications include circuit braker parts, lamp holders, heat shields,
impellers, and printer cartridges.
|
| PHYSICAL |
ASTM Test Method |
Property Value |
| Specific Gravity |
D-792 |
1.60 |
| Moisture, % |
D-570 |
|
| (50% RH) |
|
0.6 |
| (Saturation) |
|
1.6 |
| UL RATINGS |
UL Test Method |
Property Value |
| Flammability Rating, 1.5mm |
UL94 |
V-0 |
| Relative Temperature Index, 1.5mm |
UL746B |
|
| Mechanical w/o Impact, °C |
|
190 |
| Mechanical w/ Impact, °C |
|
180 |
| Electrical, °C |
|
180 |
| ELECTRICAL |
ASTM Test Method |
Property Value |
| Volume Resistivity, 1.5 mm |
D-257 |
>1E13 |
| Surface Resistivity, 1.5 mm |
D-257 |
>1E14 |
| Processing Guidelines |
|
Material Handling
Max. Water content: 0.02%
Ultrason pellets can absorb moisture very rapidly and must be dried before processing. A vacuum or dry air oven operating at 130-150 °C (266-302 °F) is recommended. Circulating air ovens are unsuitable. Drying time is dependent on moisture level, but the materials must be dried at least 4 hours. Further information concerning safe handling procedures can be obtained from the Material Safety Data Sheet. Alternatively, please contact your BASF representative.
Typical Profile
Melt Temperature 350-390 °C (662-734 °F)
Mold Temperature 150-190 °C (302-374 °F)
Injection and Packing Pressure 35-125 bar (500-1500 psi)
Mold Temperatures
Injection pressure controls the filling of the part and should be applied for 90% of ram travel. Packing pressure affects the final part and can be used effectively in controlling sink marks and shrinkage. It should be applied and maintained until the gate area is completely frozen off. Back pressure can be utilized to provide uniform melt consistency and reduce trapped air and gas. Minimal back pressure should be utilized to prevent glass breakage.
Pressures
Fast fill rates are recommended to ensure uniform melt delivery to the cavity and prevent premature freezing. Surface appearance is directly affected by injection rate.
|
| Note |
|
Although all statements and information in this publication are believed to be accurate and reliable, they are presented gratis and for guidance only, and risks and liability for results obtained by use of the products or application of the suggestions described are assumed by the user. NO WARRANTIES OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE MADE REGARDING PRODUCTS DESCRIBED OR DESIGNS, DATA OR INFORMATION SET FORTH. Statements or suggestions concerning possible use of the products are made without representation or warranty that any such use is free of patent infringement and are not recommendations to infringe any patent. The user should not assume that toxicity data and safety measures are indicated or that other measures may not be required. |
|
|
